EARN SCOTTY POINTS WITH EVERY PURCHASE CLICK HERETO FIND OUT MORE

Sorry, geocacheland.com is temporarily closed until 11th Sep 2019 due to GeoCoinfest Europe and stock taking. Contact us on info@geocacheland.com with any questions.

Write a review

Gorilla Wood Glue

3102700

£5.00

Sorry, the shop is currently closed during GeoCoinfest Europe. We will be re-opening 11th Sep 2019

Qty

Tough, Versatile, Dries Natural Color

Gorilla Wood Glue is the adhesive that woodworkers, carpenters and hobbyists trust for their woodworking projects. Gorilla Wood Glue, a PVA glue, offers the benefits of an easy-to use, water-based adhesive, with the holding power Gorilla is known for. This PVA glue is incredibly water resistant and dries a natural color that offers an invisible bond line for your projects. Perfect for sticking cloth tape to the outside of geocaches.

236ml bottle
Directions
  1. Application

    For best results, it is essential that the wood surfaces are prepared prior to application of glue. For laminating, the surfaces should be planed smooth, leaving the board surface free from machine marks, tear-out and snipes. Also, be careful to avoid burnishing and end snipes. Click here for more tips on Surface Preparation. Just how much Gorilla Wood Glue to apply depends on many factors. In general, apply a generous amount of glue on one of the surfaces. On hard-to-glue woods, apply the glue on both surfaces. Rub together with the other surface to distribute the glue evenly on both surfaces. Enough glue should be applied so that a fine bead of glue squeeze-out will occur when clamping. Coverage: 4 litres of Gorilla Wood Glue will cover about 18 square meters. 0.03 liters will cover approximately 0.15 square meters.

  2. Gripping

    The technique and type of grip to be used is determined by many factors: the specific type of joint, type of stock or lumber, moisture content of stock, room temperature, assembly time and surface quality. In general, apply enough pressure that will cause a fine bead of glue to squeeze out when the proper pressure is applied.

    Gripping Time (amount of time pressure needs to remain applied): 2030 minutes for room temperature applications. The temperature must be above 13°C. Note that clamping time can be dependent on temperature, humidity, and the porosity of the wood.

    Cure Time (amount of time for glue to reach total bonding strength): 24 hours

  3. Clean Up

    Clean up while glue is wet: Use a clean, damp cloth to wipe off excess glue. Make as many passes as needed with the clean area of the cloth to remove all the glue. When areas have completely dried, sand as needed. Wash hands, skin and damp cloths in soap and warm water, then rinse.

    Clean up when glue has dried: Use a sharp putty knife, razor, or sharp scraper to shave hardened glue from surface, then sand as needed. Soak hands and skin in soap and warm water, wash, then rinse.

    Cleaning the bottle tip: Use a clean, damp cloth to wipe off excess glue after closing. If tip becomes clogged with dry glue, remove the cap and push the clog backwards with a toothpick, then rinse cap with warm water.

    To remove Gorilla Wood Glue from hands, wash with warm soap and water.